| |
| |
| |
| LOOP POWERED ISOLATOR ---------------------------------------------------------------------------LP2SI |
| |
| |
 |
4~20 mA in, 4~20 mA out
Isolation between input and output :
1.5 KV AC RMS / 1 minute,
250 V AC RMS continuous
0.1% transfer accuracy
5 V loop drop
0~500 Ω load without trimming
DIN rail mounting
No power supply required
|
 |
|
| |
| LP2SI is a loop powered isolator suitable for a variety of applications. It can be used, for example, to isolate the 4~20mA current signal from a 2-wire thermocouple transmitter or temperature controller, and pass it on to a PLC or datalogger. LP2SI eliminates earth and ground loop problems and simplifies interfacing. LP2SI does not require load trimming. Its accuracy is specified for any load between 0 & 500 ohms. |
|
| |
| SPECIFICATIONS All specifications at ambient of 25 °C, unless specified otherwise. |
| |
| INPUT |
|
| Input current |
4~20 mA DC |
| Voltage drop across |
<5 V DC with zero ohms load |
| input terminals |
on output |
| Reverse polarity |
Provided for current inputs |
| Protection |
|
| Maximum input current |
50 mA |
| OUTPUT |
|
| Nominal current transfer |
1:1 in the range of 4~20 mA |
| ration |
|
| Permissible load |
0~500 ohms without load trim |
| resistance |
|
| ACCURACY |
|
| Linearity & calibration |
<0.1% of span
(I out = I in ± 16 μA) |
| Temperature coefficient |
0.01% of span per °C |
| of accuracy |
|
|
| ISOLATION |
|
| Input / Output isolation |
a) 1.5 KV AC RMS, 1 minute
b) 250 V AC RMS, continuous
|
| CALIBRATION |
|
| Zero, span |
20-turn potentiometers on front face |
| ENCLOSURE |
|
| Material |
ABS plastic |
| Dimensions |
80(H) x 25(W) x 85(D) mm |
| Mounting |
snap on for 35 mm DIN rail to DIN 46277 |
| Connection, single / |
≤ 2.5 mm2, AWG 14 |
| stranded wires |
|
| Weight |
<200 grams |
| Protection |
IP 20 |
| TEMPERATURE, HUMIDITY |
|
| Ambient, storage |
-20 to + 85 °C |
| Ambient, operation |
-20 to +70 °C |
| Relative humidity |
0~95% |
|
|
| |
|
